Monoprice 10221 Speaker Volume Control with IR Repeater User Manual download pdf

Speaker Volume Controller

With IR Repeater

Slide type – PID#10221

Features

o Impedance matching supports up to 16 speaker pairs

o Supports up to 100 watts/channel at 8 ohms impedance

o Compatible with 12-22AWG speaker wire

o Slide type volume control with 12 steps

o Built-in single-band (38KHz ± 2KHz) IR repeater

o 2.71" (69mm) mounting depth

Package Contents

After receiving product, please inventory the contents to ensure

you have all the proper parts, as listed below. If anything is

missing or damaged, please contact Monoprice Customer

Service for a replacement.

o 1x Slide type 100 watt/channel volume control

o 2x 3/4" screws

o 2x 1/8" screws

o 1x Interior plate

o 1x Outer plate

o 1x User's manual

Installation Instructions

NOTE: The blue INPUT L/R and OUTPUT L/R speaker wire

terminal blocks can be removed from the volume control unit,

making it easier to make the speaker wire connections. To do so,

pull straight out, away from the circuit board.

1. Remove about 1/4" of insulation from the ends of all wires to

be connected to the volume control. Twist the exposed wire to

ensure no stray strands are sticking out of the bundle.

2. Connect the wires from the output of your amplifier to the

INPUT L/R terminals on the volume controller. Ensure that the

right and left channels are properly connected and that the +

and - polarity is properly maintained. Tighten the screws

firmly.

3. Connect the wires from your speakers to the OUTPUT L/R

terminals on the volume controller. Ensure that the right and

left channels are properly connected and that the + and -

polarity is properly maintained. Tighten the screws firmly.

4. (Optional) To setup the volume control to relay IR remote

control signals to the source device, perform the following

steps:

4a. Obtain a 12 VDC/500mA AC Adapter (not included) and

cut off the DC barrel connector (if applicable). Remove

about 1/4" insulation from the wires. Twist the exposed

wires to ensure no stray strands are sticking out of the

bundle.

4b. Connect the positive wire from the 12VDC/500mA adapter

to the V+ terminal on the volume control. Connect the

negative wire to the G (ground) terminal on the volume

control.

4c. Obtain an IR transmitter bulb (not included). Remove

about 1/4" insulation from the wires. Twist the exposed

1 2 3 4

Summary of Contents

Page 1 - Slide type – PID#10221

Speaker Volume Controller With IR Repeater Slide type – PID#10221 Features o Impedance matching supports up to 16 speaker pairs o Supports up to 10

Page 2

wires to ensure no stray strands are sticking out of the bundle. 4d. Connect the positive wire from the IR transmitter bulb to the IR terminal on t

Page 3 -

Jumper settings Assembly diagram Connection diagram Mounting depth：2.71” (69mm) from finished wall.

Page 4 - Speaker Volume Control

Speaker Volume Control with Infrared Repeater Slide type – PID#10221 USER'S MANUAL

Comments to this Manuals

No comments

Monoprice 10221 Speaker Volume Control with IR Repeater User Manual

Browse online or download User Manual for Audio accessories Monoprice 10221 Speaker Volume Control with IR Repeater. Monoprice 10221 Speaker Volume Control with IR Repeater User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Audio accessories Monoprice 10221 Speaker Volume Control with IR Repeater